|
DOS Installation
The following are instructions to install Shop
Trac onto a machine running a standard version of
DOS. Shop Trac supports all common DOS
equivalents including MS-DOS, PC-DOS and DR-DOS.
 | Insert the 'Master Install Disk' into your floppy
drive. |
| From a DOS prompt input the command d:\INSTALL
where the d is replaced with the drive ID of the
floppy drive. The command A:\INSTALL would be
used if installing from the floppy diskette in
the A: drive. |
| This will load and execute the installation
program. This program should be self explanatory.
It will ask a few questions, and offer its own
default values. In most cases you should be able
to use these defaults. Consult the users manual
for additional information. |
| Some changes to your CONFIG.SYS and AUTOEXEC.BAT
files may be required. The installation procedure
will give you the option of making these changes
for you, or indicating what changes are needed
and let you make these changes yourself. Unless
you are familiar with changing the system files,
it is advisable that you allow the installation
routine to make the changes for you. |
After the installation is complete it will be
necessary to reboot your machine so that changes to the
configuration files can take effect. To load Shop
Trac simply type TRAC at a DOS prompt.
|
|
Web Site News!
|
|
This box will always give you the latest news
about changes to this site.
The
Shop Trac FAQ has been updated!
New
Shop Trac
Tech Tips, including the changes for the Canadian
July 2010 HST rate changes.
New 2010 price lists have been posted.
The latest
Shop Trac Update
is dated 09/15/2010, and an order form can be
downloaded here.
The Update Installation process has changed
slightly, and the new instructions are available
here.
The latest (and final)
IMS/ACTR/ACTP Update is dated
11/30/2003. |
|
<%=Session("UserName")%> 
